361 no clean cleanliness requirements results

Issues of Burnt Flux on Class 3 PCB Assemblies - EPTAC - Train. Work Smarter. Succeed

| https://www.eptac.com/faqs/soldertips/soldertip/issues-of-burnt-flux-on-class-3-pcb-assemblies

. I understand that if the laminate is burnt it is a defect condition, but I am not clear on burnt flux for a no-clean process. Any clarification would be appreciated. Answer

Ask Questions | EPTAC

| https://www.eptac.com/ask/

: What J-STD-001 modules are needed in order to be able to take the Space Addendum? Read Answer No Clean Flux Application and Cleaning Question

. I understand that if the laminate is burnt it is a defect condition, but I am not clear on burnt flux for a no-clean process. •  This is from IPC-A-610

| https://www.eptac.com/wp-content/uploads/2016/08/eptac_08_17_16.pdf

. I understand that if the laminate is burnt it is a defect condition, but I am not clear on burnt flux for a no-clean process. •  This is from IPC-A-610

| https://www.eptac.com/wp-content/uploads/2021/11/eptac_08_17_16.pdf

S3X58-HF1100-3 - 600 gm - PCBASupplies

| https://pcbasupplies.com/s3x58-hf1100-3-600gm/

. Type 4 No Clean Solder Paste Solution for Just About All Soldering Requirements S3X58-HF1100-3, by adopting newly developed techniques through our expertise and experiences, has gained excellent

Ask Helena & Leo (8)

| https://www.eptac.com/faqs/ask-helena-leo/page/8

. The excess no-clean flux is located in an Ethernet port connector. The units pass all tests with no issues, however; we have recently had a couple of field returns where it was

ECSS-Q-ST-70-18C

| https://www.eptac.com/wp-content/uploads/2015/03/ecss_q_st_70_18c-space-product-assurance-rf-coax-cables.pdf

 technology  see ECSS‐Q‐ST‐70‐71.  Some mounting  requirements  for  alternative  technologies  are given  in  clause  5.6.3 of this Standard.  12  ECSS‐Q‐ST‐70‐18C  15 November 2008  5 Requirements 5.1 Preparatory conditions 5.1.1 Facility cleanliness a

(cont.) •  Q:  If  using  low  solid  flux  (no  clean)  was  the  flux   heat  acclean  up  the  light  oxida

| https://www.eptac.com/wp-content/uploads/2014/05/eptac_06_18_14.pdf

PCBA Cleaning Machine / PCB Defluxing -For Best Coating and Bonding Effect - I.C.T SMT Machine

| https://www.smtfactory.com/PCBA-Cleaning-Machine-PCB-Defluxing-For-Best-Coating-and-Bonding-Effect-id43566387.html

cleaning is a full and important production step. But even with the so-called no-clean manufacturing, it may be that these components must be cleaned to avoid malfunctions

Soldering Stranded Wire - EPTAC - Train. Work Smarter. Succeed

| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-stranded-wire

: Once a wire is pre-tinned with lead free – no clean solder, can it then be considered solid wire and then be soldered to a PCBA using water soluble flux?   Question