| http://etasmt.com/cc?ID=te_news_bulletin,7161&url=_print
). The aim of the process is to form acceptable solder joints by first pre-heating the components/PCB/solder paste and then melting the solder without causing damage by overheating
| https://www.eptac.com/faqs/ask-helena-leo/ask/charring-of-wire-insulation
: We have an ongoing debate regarding the charring of wire insulation. IPC-A-610E is very clear on the topic. Aside from overheating damage to the PCB, what other dangers does this pose
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/industrial-coating-systems/products/can-manufacturing-induction-dryers-and-heaters/isc2-pre-cure-oven
overheating during line stoppages Front panel LED diagnostics provide quick, simple troubleshooting and maintenance Easily mounts over existing conveyor with minimal line modification for easy installation Contact Us By Phone: USA +1.800.433.9319 CAN +1.800.463.3200 UK +44.161.498.1500 Other Countries On-line
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_pcb-via-terms-and-applications_topic1596.xml
. These can be found under chips that will be giving off a lot of heat where overheating is a concern. Non Conductive: usually done to prevent solder or other contaminants from entering the via or provide structural support for a copper pad covering the open hole in the case of a Via In Pad
| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-pth-components-in-line-with-stranded-wire
. Specifically Section 4, Paragraph 4.18. The intent is to get good wetting between the wire and the component. The problem you may face is overheating the component when connecting the wire to the component itself and from your description you are soldering 2 wires to each component, one wire at each end
| https://www.eptac.com/faqs/ask-helena-leo/ask/darkened-smt-capacitor-or-resistor-terminations-after-leadfree-soldering-reflow
. According to everything (e.g.,.Data Sheets, mole profiles, oven temps), we are not overheating any of these components. I am wondering if anyone else has had this particular condition occur? Answer
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/select/technologies-or-options/full-surface-preheating
infrared emitters are adjusted accordingly. The user can specify a desired preheat temperature and the machine heats the assembly precisely to that range which prevents overheating of the assembly
| https://www.eptac.com/ask/soldering-pth-components-in-line-with-stranded-wire/
. Specifically Section 4, Paragraph 4.18. The intent is to get good wetting between the wire and the component. The problem you may face is overheating the component when connecting the wire to the component itself and from your description you are soldering 2 wires to each component, one wire at each end
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/select/soldering-processes/selective-vs-manual-soldering
: • Process optimization can be obtained securely and quickly • Ensures reliable solder joints without overheating components • Process reproducibility is guaranteed
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/pcb-via-terms-and-applications_topic1596_post6956.html
. These can be found under chips that will be giving off a lot of heat where overheating is a concern. Non Conductive: usually done to prevent solder or other contaminants from entering the via or provide structural support for a copper pad covering the open hole in the case of a Via In Pad
