| http://etasmt.com/te_news_bulletin/2020-09-19/19361.chtml
. Reflow solder joints first need to have good electrical conductivity. Generally speaking, a good reflow solder joint should be a metal compound formed by the mutual expansion of the solder and the surface of the metal to be soldered, rather than simply attaching the solder to it
| http://etasmt.com:9060/te_news_bulletin/2020-08-25/18961.chtml
. Reflow solder joints first need to have good electrical conductivity. Generally speaking, a good reflow solder joint should be a metal compound formed by the mutual expansion of the solder and the surface of the metal to be soldered, rather than simply attaching the solder to its surface
| http://etasmt.com/te_news_bulletin/2020-08-25/18961.chtml
. Reflow solder joints first need to have good electrical conductivity. Generally speaking, a good reflow solder joint should be a metal compound formed by the mutual expansion of the solder and the surface of the metal to be soldered, rather than simply attaching the solder to its surface
Imagineering, Inc. | https://www.pcbnet.com/blog/5-signs-your-pcb-may-need-to-be-repaired-or-replaced/
. Luckily, there are many ways to help maintain your PCBs and repair them on your own. Simple problems you can fix on your own include intermittent loss of power, overheating, non-responsive components, physical damage (including corrosion
| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-pth-components-in-line-with-stranded-wire
: Can a PTH component (resistor, fuse, or solid wire) be reliably soldered in-line with stranded wire? Similarly to a wire lap joint, but with a component between the two wires
| https://www.eptac.com/ask/soldering-pth-components-in-line-with-stranded-wire/
: Can a PTH component (resistor, fuse, or solid wire) be reliably soldered in-line with stranded wire? Similarly to a wire lap joint, but with a component between the two wires
| http://etasmt.com/te_news_bulletin/2019-10-21/11361.chtml
vehicles.Components were mechanically redesigned to have small metal tabs or end caps that could be directly soldered to the surface of the PCB. Components became much smaller and component placement on both sides of a board became far more common with surface mounting than through-hole mounting, allowing much higher circuit densities and
| https://www.eptac.com/blog/the-5-essential-tools-for-soldering?hsLang=en
. Under-powered irons also take longer to heat the joint, potentially overheating the component being soldered and cause damage. A soldering pencil is used for soldering small metallic elements and electrical components
| https://www.eptac.com/the-5-essential-tools-for-soldering/
. Under-powered irons also take longer to heat the joint, potentially overheating the component being soldered and cause damage. A soldering pencil is used for soldering small metallic elements and electrical components
winsouce.jpg)
