PCB Libraries, Inc. | https://www.pcblibraries.com/forum/ipc7093a-btc-qfn-solder-mask-defined-thermal-pad_topic2154_post10556.html
0.25 mm spacing between paste mask apertures. I see some designers overlap the thermal tab paste mask with the signal pin paste mask and that stencil will not work
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/naming-convention_topic3182.html
: 14 Post Options Post Reply Quote kfisher Report Post Thanks(1) Quote Reply Posted: 03 Jan 2023 at 11:17am One of the benefits that drew us to the "PCB Libraries" naming convention over 7351B was avoidance of name overlap
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/solder-masks_topic1380_post5510.html
. They will swell your outer layer pads, traces and vias to compensate for their etching process. They will trim all silkscreen that violates solder mask overlap. They
Imagineering, Inc. | https://www.pcbnet.com/blog/pcb-board-design/
. Make sure never to design a PCB where connections have to cross, as this can cause an overlap in signals that may ruin your design
ORION Industries | http://orionindustries.com/pdfs/kapton.pdf
splicing tape is used. Heat Seal Splices Overlap heat seal splices are made on all FN films, except 250FN029, with an overlap that is a mini- mum of 3⁄8″ (9.5 mm) wide. On 250FN029, a butt splice is made using 120FN616 as the joining tape applied on the FEP
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/0402-min-size-land-pattern_topic30&OB=DESC_page1.html
±0.15mm tolerance as found in Kemet datasheet http://www.kemet.com/Lists/ProductCatalog/Attachments/351/KEM_CC103_AUTO_SMD.pdf and calculated pads will overlap
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/0402-min-size-land-pattern_topic30_post6316.html
±0.15mm tolerance as found in Kemet datasheet http://www.kemet.com/Lists/ProductCatalog/Attachments/351/KEM_CC103_AUTO_SMD.pdf and calculated pads will overlap
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/orcad-17-2-decimal-separator-issue_topic2060_post8563.html
17.2 S009 this is broken. The sizes of the pads are way too big, so they cannot be placed (they overlap). It seems that the script files that are used to make the pads now need to use the regional decimal separator setting
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/orcad-17-2-decimal-separator-issue_topic2060_post8484.html
17.2 S009 this is broken. The sizes of the pads are way too big, so they cannot be placed (they overlap). It seems that the script files that are used to make the pads now need to use the regional decimal separator setting
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic2060&OB=ASC.html
17.2 S009 this is broken. The sizes of the pads are way too big, so they cannot be placed (they overlap). It seems that the script files that are used to make the pads now need to use the regional decimal separator setting