PCB Libraries, Inc. | https://www.pcblibraries.com/forum/0402-min-size-land-pattern_topic30_post5802.html
). The component manufacturer's often provide unrealistic tolerances and if you use them for these micro-miniature 2-pin components the resulting pad (land) size is too large
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/topic30&OB=ASC.html
). The component manufacturer's often provide unrealistic tolerances and if you use them for these micro-miniature 2-pin components the resulting pad (land) size is too large
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic30&OB=ASC.html
). The component manufacturer's often provide unrealistic tolerances and if you use them for these micro-miniature 2-pin components the resulting pad (land) size is too large
| http://etasmt.com/cc?ID=te_news_industry,23962&url=_print
. Is the layout designed for the PIP process? If the PCB hole diameter is too big, it will require too much solder to fill it up. If it is too small, it is very difficult to fill the hole properly with paste during solder paste printing
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/efd/blog/012821-medical-manufacturing-ways-to-improve-fluid-dispensing-control
. With the old method, the beads were either too thick, too thin, or overlapped, and the dots of paint were too big or too small. Sometimes the beads or dots were dragged across the surface, rendering the product unusable
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/no-silk-on-dpak_topic1242_post4873.html
, then they should be able to work with something as big as a DPAK. I suspect something in the library data is out of whack and needs some attention
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/no-silk-on-dpak_topic1242_post4880.html
, then they should be able to work with something as big as a DPAK. I suspect something in the library data is out of whack and needs some attention
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1242&OB=ASC.html
. While I selected the package to start from SM.fpx, I specified the manufacturer's recommended spacing on the final pads. FPX then told me it couldn't output any Silkscreen because the geometry was too small
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/no-silk-on-dpak_topic1242_post4881.html
, then they should be able to work with something as big as a DPAK. I suspect something in the library data is out of whack and needs some attention
| http://etasmt.com:9060/te_news_industry/2021-08-31/23962.chtml
. Is the layout designed for the PIP process? If the PCB hole diameter is too big, it will require too much solder to fill it up. If it is too small, it is very difficult to fill the hole properly with paste during solder paste printing
.gif)
winsouce.jpg)