ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/efd/blog/053118-how-to-select-the-best-fluid-reservoir-for-your-dispensing-application
. If you find your process requires multiple 10cc syringe barrels per station per shift, it may be time to opt for a larger syringe, cartridge, or even a tank to reduce the downtime it takes to swap
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/products/conformal-coating-equipment?con=t&page=30
SELECT On display will be the Cerno® 103IL featuring advanced process controls and the In-line Flux and Preheat Module with concurrent fluxing and preheating Nordson SELECT Appoints smartTec GmbH as European Distributor for Entire
| http://etasmt.com/cc?ID=te_news_industry,24163&url=_print
, profile test and formal production can only be started after oven has been run for at least 30 minutes. (c) After profiles are printed out, equipment should be adjusted, based on preheat temperature and time, reflow peak temperature, reflow time
| http://etasmt.com/te_news_industry/2021-09-01/24163.chtml
). If preheat temperature is too low, flux may not be activated fully. Preheat time: It depends on the component with highest heat capacity, PCB area, PCB thickness and performance of solder paste used. Generally, 80~160
| http://etasmt.com:9060/te_news_industry/2021-09-01/24163.chtml
). If preheat temperature is too low, flux may not be activated fully. Preheat time: It depends on the component with highest heat capacity, PCB area, PCB thickness and performance of solder paste used. Generally, 80~160
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/select/about/news/nordson-select-to-exhibit-latest-selective-soldering-technology-at-the-2018-smta-guadalajara-expo
skew correction of a printed circuit board. Also available is an optional in-line flux and preheat module with concurrent fluxing and preheating that provides significantly increased production throughput
| https://www.smtfactory.com/Good-Quality-Off-line-Selective-Wave-Soldering-Machine-SS430-China-Supplier-pd41861093.html
. I.C.T SS330 selective wave soldering is a high performance equipment developed and assembled in China. Features: 1, The piezoelectric ceramic jet valve originated in Germany is selected, which is suitable for flux with solid content less than 5
| https://www.smtfactory.com/Off-line-Selective-Wave-Soldering-Machine-SS330-pd43471093.html
. I.C.T SS330 selective wave soldering is a high performance equipment developed and assembled in China. Features: 1, The piezoelectric ceramic jet valve originated in Germany is selected, which is suitable for flux with solid content less than 5
Heller 公司 | http://hellerindustries.com.cn/00600-248.pdf
. The typical form for such a profile, Figure 1b, is commonly referred to as a “tent” or “straight ramp” profile. For no- clean pastes, which have less active fluxes, excessive dwell time serves only to deplete the flux before reflow
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/07/00600-248.pdf
. The typical form for such a profile, Figure 1b, is commonly referred to as a “tent” or “straight ramp” profile. For no- clean pastes, which have less active fluxes, excessive dwell time serves only to deplete the flux before reflow
