Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2022/04/Vacuum-Void-Reduction-Reflow-1.pdf
Vacuum Reflow Processing On Solder Joint Voiding To be published in the Proceedings of SMTA International, September 17 - 21, 2016, Rosemont, IL
Heller 公司 | http://hellerindustries.com.cn/Vacuum-Void-Reduction-Reflow.pdf
The Effect of Vacuum Reflow Processing On Solder Joint Voiding And Thermal Fatigue Reliability To be published in the Proceedings of SMTA International, September 17 - 21, 2016, Rosemont, IL
Imagineering, Inc. | https://www.pcbnet.com/blog/understanding-the-pcb-fabrication-process-from-design-to-delivery/
manufacturers are typically located outside the U.S . This post provides an overview of the PCB fabrication process, including pre-processing steps
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/07/last-will-of-bga-void.pdf
, 1.0mm pitch, various solder ball diameters SnPb solder paste Test vehicle one: 2.36mm thick (93 mil), FR-4, 8 internal planes, OSP finish Thermal cycling: 0°C-100
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2022/04/last-will-of-bga-void-1.pdf
, 1.0mm pitch, various solder ball diameters SnPb solder paste Test vehicle one: 2.36mm thick (93 mil), FR-4, 8 internal planes, OSP finish Thermal cycling: 0°C-100
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2022/06/Optimizing-Reflowed-Solder-TIM-sTIMs-Processes-for-Emerging-Heterogeneous.pdf
. Voiding is the most important failure mode and has been studied by x-ray. The effects of surface pretreatment, pressure during reflow, solder flux type/fluxless processing, and preform design parameters, such as alloy type, are also examined
Surface Mount Technology Association (SMTA) | https://www.smta.org/education/presentations/presentations.cfm
. Three surface finishes including OSP, ImAg, and ENIG are considered. The test vehicle consists of 15mm and 6mm Ball Grid Array (BGA) components. The assembled test boards were isothermally aged at 125oC for 12 months, which are then thermally cycled between -40oC to
Surface Mount Technology Association (SMTA) | https://www.smta.org/webinars/
. Three surface finishes including OSP, ImAg, and ENIG are considered. The test vehicle consists of 15mm and 6mm Ball Grid Array (BGA) components. The assembled test boards were isothermally aged at 125oC for 12 months, which are then thermally cycled between -40oC to
| 1 |
winsouce.jpg)
