| https://www.eptac.com/ask/ipc-5704-vs-ipc-6012-bare-board-cleanliness-comparison/
: I am reviewing IPC-5704, and have a question. When reviewing table 4-1, the chloride limit is 0.75 ug/cm2, which converts to 4.4 ug/in2, however; IPC 6012 still has the board cleanliness limit for sodium chloride as
| https://www.eptac.com/webinar/the-fundamentals-of-solder-joint-design-part-2-surface-mount-technology-smt/
. We continue with this series by reviewing the soldering process as it relates to SMT assemblies and how we can best interpret formulas and calculations that lead us in a direction to better
| https://www.eptac.com/webinars/the-fundamentals-of-solder-joint-design-part-2-surface-mount-technology-smt
. We continue with this series by reviewing the soldering process as it relates to SMT assemblies and how we can best interpret formulas and calculations that lead us in a direction to better
| https://www.eptac.com/webinars/the-fundamentals-of-solder-joint-design-part-2-surface-mount-technology-smt/
. We continue with this series by reviewing the soldering process as it relates to SMT assemblies and how we can best interpret formulas and calculations that lead us in a direction to better
| https://www.eptac.com/faqs/ask-helena-leo/ask/defining-standard-industry-practices-for-torque-of-threaded-fasteners
: While reviewing IPC-A-610, Section 4.1.5.1 (Torque of Threaded Fasteners), the question of “what is the standard industry practice
| https://www.eptac.com/ask/defining-standard-industry-practices-for-torque-of-threaded-fasteners/
: While reviewing IPC-A-610, Section 4.1.5.1 (Torque of Threaded Fasteners), the question of “what is the standard industry practice
| https://www.eptac.com/webinar/defects-lead-protrusion-damaged-pins/
. In addition, if you have damaged pins, are they “fixable” and what does IPC-A-610 allow you “to do” or “not to do” with this defect? Topics we will be reviewing are
| https://www.eptac.com/webinar/damage-prevention-when-soldering-ceramic-chip-capacitors/
. Topics we will be reviewing are: Fundamentals that are impacting these components. Design considerations including larger pads or land areas
| https://www.eptac.com/webinar/tempered-leads-class-3-rework-toe-fillets-and-more/
. At the end, we will open it up for a Q&A session, so that you can ask away. Topics we will be reviewing are: Tempered Leads – What they really are
| https://www.eptac.com/webinar/the-need-for-gold-removal-on-solderable-surfaces/
. Topics we will be reviewing are: The history of the process. Review of J-STD-001 Section 4.5.1 requirements. Solder joint and solder pot gold contamination
