PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/mfr-templates-maintenance_topic435.html
Posted: 21 Oct 2012 at 1:57pm If anyone creates a new "Template" for a component manufacturer that we do not support, please send it to me and I will make sure it gets added to the installer on the next release. Thanks
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/topic435&OB=ASC.html
. I noticed that some Manufacturers were not represented, i.e. "International Rectifier". I could have elected to create my own template, however I would have been on my own little island, because this New Mfr template would exist only on my PC
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/mfr-templates-maintenance_topic435_post1229.html
. I noticed that some Manufacturers were not represented, i.e. "International Rectifier". I could have elected to create my own template, however I would have been on my own little island, because this New Mfr template would exist only on my PC
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic435&OB=DESC.html
Posted: 21 Oct 2012 at 1:57pm If anyone creates a new "Template" for a component manufacturer that we do not support, please send it to me and I will make sure it gets added to the installer on the next release. Thanks
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/mfr-templates-maintenance_topic435.html
Posted: 21 Oct 2012 at 1:57pm If anyone creates a new "Template" for a component manufacturer that we do not support, please send it to me and I will make sure it gets added to the installer on the next release. Thanks
| https://unisoft-cim.com/view-markup_bom_importing-your-bom-files.html
. Note that many customers receive their BOM's in Microsoft Excel format and to save those BOM's to a TAB delimited format see the section below titled "Special note for BOM's in Microsoft Excel format
| https://unisoft-cim.com/cycle-times.html
. So 60 seconds for 1 component insertion would equate to hand placing 60 components in 1 hour in that category. From the template window in the Unisoft software in the figure below we generated the tab delimited Excel output report for the template we created above
| https://unisoft-cim.com/xyr-importing.html
"Resistor, 1k ohm, 1%" Surface Indicator: If a surface indicator such as Top, Bottom, TopLayer, or BotLayer is located in the XYR file, then it needs to be described in the XYR importer template
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/questions-answers_forum34&SO=V&OB=desc_page11.html
:10am 2 958 By Tom H 21 Oct 2012 at 1:57pm Editing FPX Files in M/S Excel Spreadsheets By jameshead , 21 Oct 2013 at 7:37am 2 955 By jameshead 21 Oct 2013 at 8:00am OrCAD (Allegro
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/questions-answers_forum34&SO=A_page15.html
< 1 13 14 15 16 17 36 > Topics / Topic Starter Rating Replies Views Last Post Forum Topics "S" dim for DFN 2 Pin & Avago template request By jameshead , 17 Sep 2012 at 1
.gif)
