PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic523&OB=ASC.html
standards. My doubt is in top of board we are not given in route or via keepouts . is this ok ? else we need give any keep outs pls suggest any one
40731 | https://www.smta.org/harsh/Harsh-Environments-Conference-2020-Sponsorships&Exhibits.pdf
Surface Mount Technology Association (SMTA)
Heller 公司 | http://hellerindustries.com.cn/00600-248.pdf
. The typical form for such a profile, Figure 1b, is commonly referred to as a “tent” or “straight ramp” profile. For no- clean pastes, which have less active fluxes, excessive dwell time serves only to deplete the flux before reflow
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/07/00600-248.pdf
. The typical form for such a profile, Figure 1b, is commonly referred to as a “tent” or “straight ramp” profile. For no- clean pastes, which have less active fluxes, excessive dwell time serves only to deplete the flux before reflow
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2022/04/00600-248-1.pdf
. The typical form for such a profile, Figure 1b, is commonly referred to as a “tent” or “straight ramp” profile. For no- clean pastes, which have less active fluxes, excessive dwell time serves only to deplete the flux before reflow
| 1 |
winsouce.jpg)