| https://pcbasupplies.com/thermaltronics-m60tz025-tweezers-cartridge-pair-knife-tinned-area-2-03mm-0-08/
» Thermaltronics M60TZ025 Tweezers Cartridge Pair – Knife Tinned area 2.03mm (0.08″) Thermaltronics M60TZ025 Tweezers Cartridge Pair – Knife Tinned area 2.03mm (0.08
| https://www.eptac.com/ask/ipc-j-std-001-5-1-3-question-on-wire-tinning/
: 5.1.3 States that wires must be tinned if soldered to boards with some exceptions. My question is if the stranded wire is individually tinned wire, not “topcoat
| https://www.eptac.com/faqs/ask-helena-leo/ask/ipc-j-std-001-5-1-3-question-on-wire-tinning
: 5.1.3 States that wires must be tinned if soldered to boards with some exceptions. My question is if the stranded wire is individually tinned wire, not “topcoat
| https://www.eptac.com/faqs/ask-helena-leo/ask/when-to-tin-and-not-tin-wires
: I have a connector that you insert a 7/30 wire into and hold it in place by tightening a screw. Should the wire be tinned? I have look in my IPC 620 standard and the only reference I see is Section
| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-stranded-wire
: Once a wire is pre-tinned with lead free – no clean solder, can it then be considered solid wire and then be soldered to a PCBA using water soluble flux? Question
| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-iron-tip-maintenance
. When the tinning on the tip is gone, or the tip cannot be tinned, that oxidized surface is a poor transmitter of heat and energy which is required to melt the solder to make the solder joint
| https://www.eptac.com/ask/soldering-stranded-wire/
: Once a wire is pre-tinned with lead free – no clean solder, can it then be considered solid wire and then be soldered to a PCBA using water soluble flux
| https://www.eptac.com/wp-content/uploads/2021/11/webinar_eptac_07_15_09.pdf
. 12 Crimping of Tinned Wires #3 Can and should the wires be tinned before the crimp connections is made? 13 Information from IPC-A-620
| https://www.eptac.com/faqs/ask-helena-leo/ask/what-is-the-correct-way-to-fill-solder-cups
: I noticed a lot of my techs, while soldering cups, are not putting the soldering iron on the back of the cup, filling with solder, then adding the tinned wire
| https://www.eptac.com/faqs/ask-helena-leo/ask/will-i-damage-a-wire-in-board-if-it-is-bent-too-far
. We had some assemblies built outside and they tinned and bent them at a right angle, then soldered... Question: I am an IPC Certified J-STD-001 Instructor
.gif)
winsouce.jpg)
