| https://www.eptac.com/faqs/ask-helena-leo/ask/ipc-j-std-001-5-1-3-question-on-wire-tinning
IPC J-STD-001: 5.1.3 Question on Wire Tinning - EPTAC - Train. Work Smarter. Succeed Looking for solder training standards, manuals, kits, and more
| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-iron-tip-maintenance
: Hello, I would like to know the benefits of tip tinning and tip maintenance. Is it necessary to tin and turn off irons when not in use? Question
| https://www.eptac.com/faqs/ask-helena-leo/ask/when-to-tin-and-not-tin-wires
susceptible to vibration, loosening and corrosion. By not tinning the wire, you can get a better gas tight joint. More SolderTips Visual Acuity Requirements for Soldering PEM®
| https://www.eptac.com/faqs/ask-helena-leo/ask/solder-selection-for-printed-circuit-boards-and-terminals
: I know for tinning stranded wires you should not use Type H or M flux, so we are ordering a No-clean solder Sn63Pb37 with a flux designator ROL0
| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-stranded-wire
3.3 Flux, stating within the paragraph that “… Type H or M fluxes shall not [D1, D2, D3] be used for tinning of stranded wires.” Once the wires are tinned and assembled to their respective terminations, be it either a terminal, or a printed circuit board, other approved fluxes can be used to make those connections
| https://www.eptac.com/faqs/ask-helena-leo/ask/air-bubbles-or-voids-in-solder-joints
: Air bubbles or voids are in all the solder joints ever made, in one form or another. At times they are filled with flux or soldering tinning fluids and other times they are caused by outgassing and they are simply a void with nothing in them
| https://www.eptac.com/faqs/ask-helena-leo/ask/solder-defect-non-conformity-listing-for-ipc-a-610
4.19 Heat Shrinkable Soldering Devices 5. Wires and Terminals Connections 5.1 Wire and Cable Preparation 5.1.1 Insulation Damage 5.1.2 Strand Damage 5.1.3 Tinning of Stranded Wire
Blackfox Training Institute, LLC | https://www.blackfox.com/blackfox-courses/instructor/mechanical-assembly-series/
learning activities WHAT THE “LICENSED INSTRUCTOR” RECEIVES: An instructor guide providing complete directions for conducting course Visual aids on CD Rom/USB Drive Written exams for learner qualification Practical exam criteria Upon satisfactory completion of
