PCB Libraries, Inc. | https://www.pcblibraries.com/forum/avx-turbocap-footprint_topic42_post111.html
& Side dimensions to calculate the Pad Size and Spacing. These 7 factors are used to calculate the optimum Land Size Component Body Tolerance – ± 4 Mil (0.1) thru ± 12 (0.3
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic42&OB=DESC.html
& Side dimensions to calculate the Pad Size and Spacing. These 7 factors are used to calculate the optimum Land Size Component Body Tolerance – ± 4 Mil (0.1) thru ± 12 (0.3
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_library-expert-2016-01-released_topic1846.xml
2016.01 was just released!!NEW:IPC-7351C Solder Joint Goals:Changed all Negative solder joint goal values to zero 0Changed Fabrication Tolerance from
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/RSS_ipc2221-2222-and-throughhole-pad-stacks_topic2586.xml
applied. Here isan image of the minimum annular ring. There are 2 fabrication tolerances that must be accountedfor. The first and most obvious one is the hole size tolerance that is in thedrill chart on the fabrication drawing
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_fabrication_forum55.xml
applied. Here isan image of the minimum annular ring. There are 2 fabrication tolerances that must be accountedfor. The first and most obvious one is the hole size tolerance that is in thedrill chart on the fabrication drawing
1st Place Machinery Inc. | http://www.firstplacemachinery.com/firstplace_tenney_oven.html
: 25 5/8 x 21 7/8 x 60 Temperature Range: -75C to 200+C Control Tolerance: +/- 0.3C Watlow Programable Controller "GN2 Purge System" Data Communication
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1508&OB=ASC.html
: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5378 Post Options Post Reply Quote Tom H Report Post Thanks(1) Quote Reply Posted: 18 Dec 2014 at 3:06pm L30 = the Lead Tolerance The Nominal Lead Length may be the same but it's the Tolerance that makes the pad longer or shorter
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/adhesive-dispensing-systems/products/melters/problue-liberty-ats-system
volume upper and lower tolerance band limits to identify out-of-tolerance product Reduced char by melting what you need, when you need it Reduced energy consumption Improved flexibility with adhesive
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/topic1561&OB=DESC.html
: 40 Post Options Post Reply Quote 5not4 Report Post Thanks(0) Quote Reply Posted: 18 Feb 2015 at 9:07am Is there a 'typical' tolerance to be used when there is no value given on a datasheet
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1561&OB=ASC.html
: 40 Post Options Post Reply Quote 5not4 Report Post Thanks(0) Quote Reply Topic: Missing Tolerances Posted: 18 Feb 2015 at 9:07am Is there a 'typical' tolerance to be used when there is no value given on a datasheet