| http://etasmt.com:9060/te_news_industry/2021-08-31/23964.chtml
Soldering Defects are Related to the Incorrect Setup of the Reflow Profile? From: Author: Publish time:2021-08-31 22:36 Clicks:14 As shown in the figure below, there are four different zones in a typical refow profile
| http://etasmt.com/te_news_industry/2021-08-31/23964.chtml
Soldering Defects are Related to the Incorrect Setup of the Reflow Profile? From: Author: Publish time:2021-08-31 22:36 Clicks:9 As shown in the figure below, there are four different zones in a typical refow profile
| http://etasmt.com/cc?ID=te_news_industry,24361&url=_print
. The more efficient the heat transfer during the soak phase the less time is needed. Reflow – This is the stage where the temperature within the reflow oven is increased above the melting point of the solder paste causing it to form a liquid
| http://etasmt.com:9060/te_news_industry/2021-09-01/24361.chtml
. The more efficient the heat transfer during the soak phase the less time is needed. Reflow – This is the stage where the temperature within the reflow oven is increased above the melting point of the solder paste causing it to form a liquid. The
| http://etasmt.com/te_news_industry/2021-09-01/24361.chtml
. The more efficient the heat transfer during the soak phase the less time is needed. Reflow – This is the stage where the temperature within the reflow oven is increased above the melting point of the solder paste causing it to form a liquid. The
| http://etasmt.com/cc?ID=te_news_industry,23961&url=_print
. Soak time and TAL consideration To ensure proper temperature equalization of the whole area beneath the connector, it is recommended that the soak time is long enough as well as the time above
| http://etasmt.com:9060/te_news_industry/2021-08-31/23961.chtml
. Soak time and TAL consideration To ensure proper temperature equalization of the whole area beneath the connector, it is recommended that the soak time is long enough as well as the time above
| http://etasmt.com/te_news_industry/2021-08-31/23961.chtml
. Soak time and TAL consideration To ensure proper temperature equalization of the whole area beneath the connector, it is recommended that the soak time is long enough as well as the time above
