PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_2-pad-chips-with-different-lead-length_topic1988.xml
. However, I am unable to do the same with components that have different lead lengths.I.E. the "T" value in the drawing below are different and have different tolerances on either side of the
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_library-expert-2016-03-released_topic1875.xml
parts will now have proper naming that uses the h value to denote hole sizeExpedition:Adjusted the ASCII Keep-out translation to support Placement Keep-outs along with Plane Obstructs
PCB Libraries, Inc. | https://www.pcblibraries.com/Forum/minimum-trim-standoff-height_topic1603_post6530.html
. You decide what the minimum A1 value is for your assembly process. If you want this: "Pad is being trimmed for pads that extend under the component body" and would automatically cut the land under the body of the component
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/minimum-trim-standoff-height_topic1603.html
. You decide what the minimum A1 value is for your assembly process. If you want this: "Pad is being trimmed for pads that extend under the component body" and would automatically cut the land under the body of the component
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1603&OB=ASC.html
. You decide what the minimum A1 value is for your assembly process. If you want this: "Pad is being trimmed for pads that extend under the component body" and would automatically cut the land under the body of the component
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/topic1603&OB=DESC.html
. You decide what the minimum A1 value is for your assembly process. If you want this: "Pad is being trimmed for pads that extend under the component body" and would automatically cut the land under the body of the component
GPD Global | https://www.gpd-global.com/co_website/pdf/pbt/PBFT-Strain-Gauge-Verification-Kit-Instructions-PBT-0128.pdf
(for each hanging weight included in the kit) between the PBT pulley extension arm and the PBFT base plate and noting the value displayed on the strain gauge
GPD Global | https://www.gpd-global.com/pdf/pbt/PBFT-Strain-Gauge-Verification-Kit-Instructions-PBT-0128.pdf
(for each hanging weight included in the kit) between the PBT pulley extension arm and the PBFT base plate and noting the value displayed on the strain gauge
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/RSS_part-annotations_topic1870.xml
. Part Annotations : Are there plans to add part annotations... Author: gburns65Subject: 1870Posted: 11 Apr 2016 at 1:17pmAre there plans to add part annotations such as part value to through hole and SMD step models?
winsouce.jpg)
.gif)