| https://www.eptac.com/faqs/ask-helena-leo/ask/dip-tinning-conductors-with-low-temperature-insulation-and-solder-pot-contamination
. Tinning the wire in this condition, however; is not recommended for a variety of reasons, the least of which is the wires beneath the slug may not tin and this may also cause more penetration beneath the insulation eliminating the ability to
| https://www.eptac.com/faqs/ask-helena-leo/ask/soldering-stranded-wire
Soldering Stranded Wire - EPTAC - Train. Work Smarter. Succeed Looking for solder training standards, manuals, kits, and more
| https://www.eptac.com/soldertips/soldertip-48-the-cleanliness-of-wire-and-terminal-connections/
SolderTip #48: The Cleanliness of Wire and Terminal Connections | EPTAC Skip to content Scroll Toll Free: 800.643.7822 Toggle navigation Training All Classes
| https://www.eptac.com/soldertip/soldertip-48-the-cleanliness-of-wire-and-terminal-connections/
SolderTip #48: The Cleanliness of Wire and Terminal Connections - EPTAC - Train. Work Smarter. Succeed Looking for solder training standards, manuals, kits, and more
| https://www.eptac.com/faqs/soldertips/soldertip/soldertip-48-the-cleanliness-of-wire-and-terminal-connections
SolderTip #48: The Cleanliness of Wire and Terminal Connections - EPTAC - Train. Work Smarter. Succeed Looking for solder training standards, manuals, kits, and more
| https://www.eptac.com/faqs/ask-helena-leo/ask/when-to-tin-and-not-tin-wires
susceptible to vibration, loosening and corrosion. By not tinning the wire, you can get a better gas tight joint. More SolderTips Visual Acuity Requirements for Soldering PEM®
| https://www.eptac.com/faqs/ask-helena-leo/ask/solder-defect-non-conformity-listing-for-ipc-a-610
4.19 Heat Shrinkable Soldering Devices 5. Wires and Terminals Connections 5.1 Wire and Cable Preparation 5.1.1 Insulation Damage 5.1.2 Strand Damage 5.1.3 Tinning of Stranded Wire
| https://www.eptac.com/faqs/ask-helena-leo/ask/solder-selection-for-printed-circuit-boards-and-terminals
: I know for tinning stranded wires you should not use Type H or M flux, so we are ordering a No-clean solder Sn63Pb37 with a flux designator ROL0