Technical Library | 2016-08-11 15:49:59.0
The challenge for 3D IC assembly is how to manage warpage and thin wafer handling in order to achieve a high assembly yield and to ensure that the final structure can pass the specified reliability requirements. Our test vehicles have micro-bumped die having pitches ranging from 60um down to 30um. The high density of pads and the large die size, make it extremely challenging to ensure that all of the micro-bump interconnects are attached to a thin Si-interposer. In addition, the low standoff between the die and interposer make it difficult to underfill. A likely approach is to first attach the die to the interposer and then the die/interposer sub-assembly to the substrate. In this scenario, the die/interposer sub-assembly is comparable to a monolithic silicon die that can be flip chip attached to the substrate. In this paper, we will discuss various assembly options and the challenges posed by each. In this investigation, we will propose the best method to do 2.5D assembly in an OSAT(Outsourced Assembly and Test) facility.
Technical Library | 2010-06-30 17:43:04.0
As silicon technology advances to enable higher density ASICs, the core logic voltage decreases. The lower voltage, in combination with higher current requirements, requires tighter tolerances on the power supplies. The control of the power supplies from the PCB to the die is the subject of this study. A frequency sweep simulation using typical bypass values shows that a discrete package capacitor is not a significant factor in reducing the chip core power supply fluctuation. A small voltage boost at the PCB supply can provide a more economical solution to managing the device supplies.
| 1 |
