Technical Library | 2018-08-08 21:55:00.0
180 °C and Td >400 °C. In addition to a high thermal stability, Material A also shows a dielectric loss factor lower than commercial phosphorus-based flame retardants.
Technical Library | 2015-09-10 15:06:17.0
A new non-halogen flame retardant has been developed and is useful for a variety of high performance applications. This non-reactive phosphorus-based material satisfies fire safety needs for a broad range of resins including epoxy, polyolefin, and polyamide. The combination of excellent flame retardant efficiency, high thermal stability and exceptional electrical properties is unique to this organophosphorus flame retardant and makes it a breakthrough technology for high speed, high frequency use in fast growing wireless and wired infrastructures. Resin performance data, including formulations with synergists, are presented in this paper.
Technical Library | 2015-11-25 14:15:12.0
In this study various printed circuit board surface finishes were evaluated, including: organic solderability preservative (OSP), plasma finish (PF), immersion silver (IAg), electroless nickel / immersion silver (ENIS), electroless nickel / immersion gold hi-phosphorus (ENIG Hi-P), and electroless nickel / electroless palladium / immersion gold (ENEPIG). To verify the performance of PF as a post-treatment option, it was added to IAg, ENIG Hi-P, and ENEPIG to compare with non-treated. A total of nine groups of PCB were evaluated. Each group contains 30 boards, with the exception on ENIS where only 8 boards were available.
Technical Library | 2023-01-10 20:15:42.0
Over the past years there has been consistent growth in the use of electroless nickel / immersion gold (ENIG) as a final finish. The finish is now frequently being used for PBGA, CSP, QFP and COB and more recently gathered considerable interest as a low cost under-bump metallization for flip chip bumping application. One of the largest users for this finish has been the telecommunication industry, were millions of square meters of PCBs with ENIG have been successfully used. The nickel layer offers advantages such as multiple soldering cycles and hand reworks without copper dissolution being a factor. The nickel also acts as a reinforcement to improve through-hole and blind micro via thermal integrity. In addition the nickel layer offers advantages such as co-planarity, Al-wire bondability and the use as contact surface for keypads or contact switching. Especially those pads, which are not covered by solder need a protective coating in corrosive environment – such as high humidity or pollutant gas.
| 1 |
winsouce.jpg)
