Used SMT Equipment | Soldering - Reflow
Outstanding condition in every respect. Would blend in with a brand new SMT line no problem. * No2 option installed and production ready * Polar Closed loop cooling option * Edge pin chain for Large board out to 20" wide operation * Center board
Used SMT Equipment | Soldering - Reflow
Vitronics XPM2-1030 Reflow Oven Nitrogen Polar Cooling Edge Pin Chain Center Board Support SMEMA Auto Rail Adjust Opens 20" Wide 02 oxygen analyzer Flux Evacuation System Auto Chain Lube System UPS Backup 3PH 440V 50kVA Made in USA
Used SMT Equipment | Depanelizers / Routers
New PC controller installed 3 years ago Manuals included Backup hard drive included General cutting bits included Dimms: 49" x 52" x 69" @ 1,350 lbs This unit is located in the CEE facility in the Chicago area. A CEE technician wil
Used SMT Equipment | Chipshooters / Chip Mounters
Fuji AIMEX III Pick and Place Machine (Low Hours!) High Speed Flex Placer DOM: 2020 (installed 11/2020) Hours: 2700 Dual Gantry DX - DynaHead ITS - InterTray Station MFU with Power Supply Backup pin picker tool R12 auto-tool R4 auto-tool Auto-too cas
Used SMT Equipment | Soldering - Reflow
Low Hour Heller 1707MK5 Ultra Low Nitrogen & Power Consuption Reflow Oven Available (7) Top/Bottom Lead Free Heat Zones Edge Rail With Auto Lubrication & Mesh Conveyor (Left to Right Travel) 45MM Clearance Above & Below Edge Rail Conveyor Pins Inert
Used SMT Equipment | In-Circuit Testers
The Agilent 5071A primary frequency standard delivers unsurpassed accuracy, stability and reliability for the most demanding laboratory and field applications. It is the first caesium (cesium ) standard to specify its stability for averaging times lo
Used SMT Equipment | Soldering - Reflow
Eco Automation EcoFlow DK-8C-500 2005 The oven was built in 2005, refurbished and upgraded in 2009, 8 vertical convection heating zones, robust cooling zone, mesh and edge conveyors, computer and touchpad backup controls, chain oilers ready for produ
Used SMT Equipment | Soldering - Reflow
Eco Automation EcoFlow DK-8C-500 2005 The oven was built in 2005, refurbished and upgraded in 2009, 8 vertical convection heating zones, robust cooling zone, mesh and edge conveyors, computer and touchpad backup controls, chain oilers ready for produ
Used SMT Equipment | Pick and Place/Feeders
2005 and factory refurbished in 2014 and always serviced by MyData under the "MYCARE" program. Software Rev. is 2.4.6B. Last factory service on this machine was this past spring. Machine has 20,267 hours of power on time, 8 days and 13
Used SMT Equipment | Soldering - Reflow
Soon to be available: 2014 Heller 1810MKIII Solder Paste Reflow Oven 480VAC, L to R Board Flow, 18" Wide Mesh Belt and Pin Chain Conveyor, Computer controlled Conveyor Width Adjust, Auto Lube, Inert Atmospher for N2, Ultra Low Consumption Nitr
.png)
