Used SMT Equipment | Soldering - Reflow
• Nitrogen • Edge Belt Conveyor • Mesh Belt Conveyor • Auto Chain Oiler • 350 C Max Temp • Flux Management System • 480, Volt, (3) Phase • (10) Upper and (10) Lower Convection Heating Zones • (2) Cooling Zones • Condition: Complete & Operat
Used SMT Equipment | Soldering - Reflow
Vintage: 2006 Details: • 7 zone, 1 cooling zone • Rail & Mesh • No center rail support • Auto chain oiler (not enabled) • Controller: Intellimax 2 • Software rev: Wiscon 6.0 • Has air cooling
Used SMT Equipment | Soldering - Reflow
BTU Pyramax 100A Reflow Oven Vintage: 2012 LOW HOURS Edge Rail Mesh Belt L to R Flow Programmable Width Adjust Smart Tracker SMEMA Bottom Cooling Fans 480V 3-Phase UPGRADE Kit Recently Added ($13k Value) - Intellimax 2 Module Assembly - Wincon 7.2 So
Used SMT Equipment | Circuit Board Assembly Products
8 Zones (7 heat and 1 cooling). Nitrogen capable, mesh belt, edge rail and a center rail that has been disengaged. 480 volt, 3 phase, new 2006.
Used SMT Equipment | X-Ray Inspection
CRX2000 X-Ray Inspection System. Fully Factory Refurbished in 2011 including new 130KVA tube. Extremely light usage since upgrade. AUCTION ITEM: Assembly Plus Phoenix, AZ www.xlineassets.com Complete Factory Closure - Other Equipment A
| 1 |
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155
