Used SMT Equipment | SMD Placement Machines
* DOS * Flying Nozzle change * Fiducial camera * Pneumatic tape feeder * Locate Pin * Edge clamp * Z servo push plate * Entrance sub stop * Exit sub stop * Auto width adjust * Feeder float detection
Used SMT Equipment | SMD Placement Machines
* Windows NT * Flying Nozzle change head * Line array camera * Pneumatic Tape feeder * Main Stopper * Locate Pin * Edge Clamp system * Z servo push up plate * Entrance sub stopper * Exit sub stopper *
Used SMT Equipment | Pick and Place/Feeders
Assembleon Topaz X Multi-Fuction Placer With LCS Available! 4 Standard Change Heads & 4 FNC Heads Component Range: 0201 to 32mm Square Placement Rate:18,000CPH (Chips), 2,500 (QPP) Maximum Board Size: 460mm x 440mm (18.1" x 17.3")
Used SMT Equipment | Flexible Mounters
DOM 6/9/1999 L to R Board Flow Light Tower Eight Spindle Placing Head – Spindles 1, 3, 5, & 7 are single nozzle spindles that use type 71A, 72A, 73A and 74A nozzles from the nozzle exchange nest. Spindles 2, 4, 6, & 8 are Flying Nozzle Chan
Used SMT Equipment | Pick and Place/Feeders
Tact time: 0.20sec/chip with line array camera Simultaneous pick with 8 heads 0.45 sec/SO with line array camera Simultaneous pick with 4 heads 1.4 sec/QFP with line array camera Sequential pick with 4 heads 3.7 sec/QFP with area CCD camera In fin
Used SMT Equipment | Pick and Place/Feeders
Tact time: 0.20sec/chip with line array camera Simultaneous pick with 8 heads 0.45 sec/SO with line array camera Simultaneous pick with 4 heads 1.4 sec/QFP with line array camera Sequential pick with 4 heads 3.7 sec/QFP with area CCD camera In fin
1 |