Used SMT Equipment | Soldering - Reflow
Production Overview: The 1700 reflow soldering oven models support high mix / medium volume throughput… at speeds up to 24 inches (60 centimeters) per minute, while conserving valuable factory floor space. Rapid response times and precis
Used SMT Equipment | Pick and Place/Feeders
8mm Quad feeders. 3 pin non-intelligent. Fits Quad C and Q series machines. Feeders have been tested for advance forward/backup on an offline feeder setup station. $50 each includes shipping to the continental U.S. Minimum quantity per order is 10 fe
Used SMT Equipment | Pick and Place/Feeders
Make: Sumsang Model: Hanwha SM482 plus Details: 1.High Mounting Speed: The theoretical speed can reach 30,000 CPH (optimal conditions) . 2.Wide Range of Component Sizes: Supports ICs from 0402 to 22mm, including CSP and reflective pin comp
Used SMT Equipment | Pick and Place/Feeders
Make: Sumsang Model: Hanwha SM482 plus Details: 1.High Mounting Speed: The theoretical speed can reach 30,000 CPH (optimal conditions) . 2.Wide Range of Component Sizes: Supports ICs from 0402 to 22mm, including CSP and reflective pin comp
Used SMT Equipment | Pick and Place/Feeders
Make: Sumsang Model: Hanwha SM482 plus Details: 1.High Mounting Speed: The theoretical speed can reach 30,000 CPH (optimal conditions) . 2.Wide Range of Component Sizes: Supports ICs from 0402 to 22mm, including CSP and reflective pin comp
Used SMT Equipment | Pick and Place/Feeders
Make: Sumsang Model: Hanwha SM482 plus Details: 1.High Mounting Speed: The theoretical speed can reach 30,000 CPH (optimal conditions) . 2.Wide Range of Component Sizes: Supports ICs from 0402 to 22mm, including CSP and reflective pin comp
Used SMT Equipment | Pick and Place/Feeders
Fuji AIMEX III Pick and Place Machine (Low Hours!) High Speed Flex Placer DOM: 2020 (installed 11/2020) Hours: 2700 Dual Gantry DX - DynaHead ITS - InterTray Station MFU with Power Supply Backup pin picker tool R12 auto-tool R4 auto-tool Auto-too cas
Used SMT Equipment | Soldering - Reflow
Vitronics XPM2 10 zone 2005 vintage. Loaded with all the right options and mint condition throughout. ultra clean system. * Edge Pin Chain conveyor * Left to Right product flow * Nitrogen Option fully installed * Center Board support * KI
Used SMT Equipment | Soldering - Reflow
Outstanding condition in every respect. Would blend in with a brand new SMT line no problem. * No2 option installed and production ready * Polar Closed loop cooling option * Edge pin chain for Large board out to 20" wide operation * Center board
Used SMT Equipment | Soldering - Reflow
Vitronics XPM2-1030 Reflow Oven Nitrogen Polar Cooling Edge Pin Chain Center Board Support SMEMA Auto Rail Adjust Opens 20" Wide 02 oxygen analyzer Flux Evacuation System Auto Chain Lube System UPS Backup 3PH 440V 50kVA Made in USA
