Used SMT Equipment | Board Cleaners
Make: Aqueous Technologies Model: Stencil Washer LD Vintage: 2010 Application: Solder Paste Removal Wash Tank Capacity: 35 Gallons (132 Liters) Maximum Stencil Size: 29" x 29" (74cm x 74cm) Full Immersion Ultrasonic: 1000 Watt Side Mounted Tran
Used SMT Equipment | Soldering Equipment/Fluxes
Model: FlexSolder W620 Vintage: 2012 (demo’ed only, never used!) Description: Inline soldering system. (With servo driven XYZ gantry, and tilt able gripper from 0° to 7° degrees for direct PCB handling) Details: • Spray fluxer •
Used SMT Equipment | Stencil Cleaners
SmartSonic Ultrasonic Stencil Wash • Model: 529 • Year: 2018 • Enviroguard-P Filtration System • Hand-Held Spray Rinse • Hand-Held Air Blow-Off • Footprint: 21.8" x 35.5" x 31"H • Wash Tank Dim
Used SMT Equipment | Pick and Place/Feeders
Usage : 68M /67M cycles Transfer Direction: Either Power: 200 - 240VAC, 3phase 60Hz Air: 4.2 CFM @ 90psi (119 liters/min @ 6.2 bars) Dimms: 66" x 89" x 75" @ 7867 lbs Product installation requirements: Power: 200 - 240VAC, 3p
Used SMT Equipment | Board Cleaners
Very Good - Like New condition 3510 Branson Ultrasonic Cleaner with digital display, heat and degauss. Well maintaned and gently used. Includes Stainless Steel Wie Basket Tray.. User Manual included Capacity : 5.7 Liter Dimensions: 11 1/2 in
Used SMT Equipment | Tape and Reel
Heraeus HT4020 : Temperature range: -70 C, +180 C, +/- 1 C after stabilization. Volume: 200 liters, 55 x 55 x 66 cm Control interface: Manual/PC. Controls software available. Signals to the outside: Two circular holes of 80mm diameter
Used SMT Equipment | Board Cleaners
Tank Capacity: 85 gallons (322 liters) Heat: 12,000 watts total heat at 230 Volt, 3 Phase. Heaters are derated at lower voltages. Overall Dimensions: 38" x 48" x 40"H Shipping Weight: Approximately 600 lbs. Evaporation Rate: 4 - 6 gallo
Used SMT Equipment | Semiconductor & Solar
Nordson MARCH AP-300 Plasma System Cleaner 100-230VAC, 50/60Hz, 3.5A @208V, Single Phase A compact and benchtop model, the Nordson March plasma system AP-300 has a volume capacity of 33.1 liters, supported by up to seven (7) adjustable shelves in
Used SMT Equipment | Coating and Encapsulation
Asymtek S-820B Spectrum PCB 2014 – Type: Brushless DC servo motors, closed-loop with encoder feedback – Encoder Resolution: 10 micrometer – Positional Accuracy: ±0.075 mm (0.003 in.), 3 sigma – Placement Acc
Used SMT Equipment | Pick and Place/Feeders
Product Details: Universal HSP 4796R-0-10530 Vintage: 10/2000 Cycle Count: 2 314 602 Power on time : 7492:46'05" AUTO on time : 4745:26'36" Stop time : 2747:20'55" Set up time : 157:44'15" test mode time : 0:05'02" - Max. 80 feeders (if only 8mm
winsouce.jpg)
