Used SMT Equipment | General Purpose Test & Measurement
System has 6 probe heads 4 upper probe heads 2 lower probes heads Currently configured for analog testing Has SMEMA connections for loader/unloader to be attached Can be used for left to right or right to left load configuration All maintenance
Used SMT Equipment | AOI / Automated Optical Inspection
Placement and solder joint inspection (reflow and wave soldering) Orthogonal camera module 8M (white LEDs): Field of view: 57.6 x 43.5 mm Resolution: 23.5 µm (standard), 11.75 µm (high) switchable with On Demand HR Number of mega pixel cameras:
Used SMT Equipment | Board Cleaners
Details: • 440v / 3 phase • 20" Conveyor width • Rinse Sink • Prewash: 2 upper/ 2 lower spray bars 5HP • Wash: 4 upper/ 4 lower spray bars 5HP Rinse: 2 upper/2 lower: closed loop DI tanks • 1
Used SMT Equipment | Soldering - Reflow
• Nitrogen • Edge Belt Conveyor • Mesh Belt Conveyor • Auto Chain Oiler • 350 C Max Temp • Flux Management System • 480, Volt, (3) Phase • (10) Upper and (10) Lower Convection Heating Zones • (2) Cooling Zones • Condition: Complete & Operat
Used SMT Equipment | AOI / Automated Optical Inspection
3D Wafer Bump &Wire Bonding AOI Inspection system Highest quality 3D Wire-Inspection. With high-resolution, complete inspection is possible even for Foot-shape. Inspect Mirror-surface without Reflection problem. As for PEMTRON'S unique optical techn
Used SMT Equipment | Board Cleaners
• Vintage 2008 • PLC based Control System • 480V AC 60Hz • Auto Stop/Stand by Mode • Final Rinse low flow sensor and alarm • Mach II Drying System • 2 upper, 2 lower jet manifolds • 15 HP blower upgrade • 18” Off Load Extension • Integrated
Used SMT Equipment | Other Equipment
A40 is the TDR robotic trolley system used to lower the basket into the degreaser. This particular model is the TDR 50 ( hold up to 110 lbs vs TD 15 which only holds up to 33 #) Details - Model B1950R degreaser with a series 8500 controller with
Used SMT Equipment | Soldering - Reflow
The latest breakthroughs associated with the Mark 5 reflow system now provide you with an even lower cost-of-ownership. Heller's new heating and cooling advances deliver up to 40% reduction in nitrogen and electrical consumption. This makes the MK 5
.jpg)
Used SMT Equipment | Pick and Place/Feeders
The ultra-flexible KE-2060 can place a wide range of components from 0603 and ICs, to odd-form, all at a high rate of speed. ■ 12,500CPH：chip (laser centering/effective tact) ■ 1,850CPH: IC (vision centering/effective tact), 3,400CPH with MNVC o
Used SMT Equipment | AOI / Automated Optical Inspection
BF-Frontier is used in the inspection of large-size printed circuit boards. In this device, the unique control sequence of software and hardware, accelerated scanning mode and stable optical illumination system can allow BF-Frontier to easily complet
