Used SMT Equipment | AOI / Automated Optical Inspection
11/07/2003 Mirtec MV-2HTL Bench Top AOI inspection machine, as pictured, 110VAC - 240VAC Single phase power per the name plate, buyer needs to confirm any transformer power in wiring - currently set to and powered up with 110VAC power in, Windows O/S
Used SMT Equipment | General Purpose Test & Measurement
Aeroflex, Inc. 6204B Microwave Test Set 10 MHz To 46 GHz The 6200B series RF and Microwave Test Sets (MTS) are an innovative range of instruments. An MTS combines the key microwave instruments for scalar network measurements, power and frequency mea
Used SMT Equipment | Pick and Place/Feeders
This pick & place machine is in fully operational condition. The PC powers up with the 460, it goes directly to the program, it can perform various moves, and the Z-axis sensor is operational. It comes with all of the following: Complete Technical
Used SMT Equipment | Coating and Encapsulation
03/2010 PVA IR2000-8-2 Curing Oven, 460VAC 3 phase power, L to R Board Flow, Edge Hold Pin Chain, 18" Max Board Width, Manual Slide Width Adjust, SMEMA, 4 Top and 4 Bottom IR Heaters, Touch Screen Operator Interface. Powered up and tested prio
Used SMT Equipment | Soldering - Reflow
SMT460C Reflow Oven Fresh out of Low Volume Lead Free Production Edge Pin Chain Conveyor and retractable center board support YOM 1999 Left To Right Ready Now Just serviced with new filters Max. Current consumption per phase (5 Heating Modules)
Used SMT Equipment | X-Ray Inspection
Nicolet X-Ray System Model: NXR 1400 Power Consumption: 600 watts X-Ray Source Energy: 10-100kv Focal Spot size: 8-45 microns (auto adjusting w/power) Image Detector Type: 4” (10cm) Spatial Resolution: >32 lp/mm Magnification: Up to 1
Used SMT Equipment | Semiconductor & Solar
Branson IPC 7102 710X/A v1.17 Plasma Cleaner appears to be in fair cosmetic condition with many signs of prior use or wear. There is NO TOP PANEL on this unit. The Power hook up needs maintenance, so no power check was done. https://www.ka
Used SMT Equipment | Conveyors
2007 Nutek Wave Solder Entrance Conveyor 220VAC Single Phase Power, L to R Board Flow, Speed control, Adjustable Height and Angle, Edge Hold Stainless Steel Pin Chain with Hold Down Guides, 16" Max Board Width, available as powered up and tested
Used SMT Equipment | Screen Printers
08/29/2008 MPM Speedline Technologies Momentum Solder Paste Screen Printer, 220VAC Single phase power and clean dry shop air required. Windows O/S, 2D Inspection, L to R Board Flow, Sinlge conveyor with Edge Clamp, Solder Paste Dispense, Venturi Va
Used SMT Equipment | Conveyors
JOT Post Reflow Accumulator Brush Conveyor:Model J218-10.6/1Date: 0111120VAC power1 Meter, L to R Board Flow, SMEMA Compliant, EPO, 18" Brush Width with Extended Entrance Brush and Hard Stop.Powered up, serviced, tested and functionality video provid
