Industry News | 2017-01-13 13:44:13.0
Visit booth 410 at Apex 2017 to see the K5000 singulate multiple pre-scored PCB panels in one pass. Panels up to 10.4" wide can be separated by placing onto an input conveyor to be passed onto the separator blades. This is the ideal system for high volume in-line singulation of LED lighting strips
Industry News | 2017-07-18 13:16:28.0
Depanelizing skip routed PCB panels up to 48" long is made simple and easy with FKN Systek’s K4000 PCB singulator. Just place the bottom scoreline of the PCB onto the linear blade and step on a guarded foot switch to bring the circular blade across the top scoreline for clean separation of the PCB panels. Right and left blade guards assure operator safety. The front and back support and take up table are height adjustable.
Industry News | 2020-07-01 12:08:16.0
For high precision low stress PCB singulation of panels with sensitive components near the parting edge, and with the smooth edge finish required by military specifications or by packaging considerations, using a Diamond Blade Saw beats routing for speed and for blade life. The saw blade, a 2.95" (75mm) diameter .021" thick diamond coated cutting disk, provides a low-stress, ultra smooth edge finish for separting panelized Printed Circuit Cards. ts which overhang the parting line will remain intact.
Industry News | 2022-02-17 12:52:30.0
Cleanly and easily separate a row of up to 10 tabs without dust. Singulating tab routed printed circuit cards in low to medium volume production quantities is safe and easy with the N115 Nibbler from FKN Systek. Two sharp support blades on either side of the tab help cleanly slice the PCBs from the tabs.
Industry News | 2022-09-21 08:26:26.0
Cut up to 10 Tabs in one Stroke
Industry News | 2019-09-06 14:46:04.0
THREE BLADE CHOICES FOR SINGULATING RECTANGULAR TAB ROUTED PCBS CLEANLY SINGULATE STANDARD AND FLEX CIRCUIT PANELS WITHOUT DUST Cleanly
Industry News | 2017-01-25 16:39:34.0
Singulating tab routed printed circuit cards in low to medium volume production quantities is safe and easy with the N100 Nibbler from FKN Systek. Blades are available in standard thicknesses of .120”, .093” and .062”. Custom sizes to match the width of the routed section can be ground. Tabs are cut cleanly on each side so that no further clean up is required to remove excess material, as is often the case when using hand tools or when breaking the panels manually. In addition, since only one tab is cut at a time, minimal stress is imparted to the board during the process as the panel is not pressed between two points during the cut.
Industry News | 2017-05-20 15:06:05.0
PCB array panelization can be a major challenge for PCB designers. Learn best practices for designing PCB boards for most efficient panelization.
| 1 |
