Industry News | 2016-02-27 22:11:00.0
GPD Global has advanced its auger pump technology with the introduction of the newly developed Precision Auger Pump. This pump was designed to offer a wide range of functionality in your process development by being compatible with a wide range of auger/cartridge assemblies.
Industry News | 2012-04-03 13:23:35.0
Aqueous Technologies Corp., North America’s largest provider of batch defluxing systems and cleanliness testing equipment, announces that it is now shipping the new EcoCycler Rinse Water Recycler.
Industry News | 2021-05-19 22:36:33.0
Calibration is the process of configuring an instrument to provide a result for a sample within an acceptable range. This process eliminated or minimized factors that cause inaccurate measurements. Although the exact procedure may vary from product to product, the calibration process generally involves using calibration instrument to test samples of one or more known values called "calibrators". The results are then used to establish a relationship between the measurement technique used by the instrument and the known values. The process in essence "teaches" the instrument to produce results that are more accurate than those that occur otherwise. The instrument can then provide more accurate results when samples of unknown values are tested in the normal usage of the product.
Industry News | 2016-02-05 11:03:21.0
CAMI Research Inc. (Acton, MA) announces a new board for its CableEye cable and harness testing systems. Populated with precision resistors, it allows users to determine empirically whether the tester requires calibration. The CB50 may be used on all CableEye models.
Industry News | 2016-07-21 23:27:53.0
CAMI Research reports that a customer has successfully tested simultaneous, multipoint continuity in a two-mile long, multicore cable (rated at 10Ω/1000ft) using a CableEye M3UH tester.
Industry News | 2018-05-16 19:52:52.0
Thermaltronics has introduced a multifunction soldering tip tester that has the following measurement functions: Tip temperature (centigrade to Fahrenheit switchable), Tip to ground resistance (ohm), Tip to ground voltage leakage (mv)
Industry News | 2015-08-05 14:49:25.0
CAMI Research announces a new, dual-purpose connector board for training new users on its CableEye cable and harness testing systems, and for performing tester system verification.
Industry News | 2018-08-21 09:19:50.0
Celebrating its 25th anniversary, CAMI Research Inc. (Acton, MA), manufacturer of the CableEye automation-ready cable and harness test system, has developed the capability of checking and measuring twist pair relationships in cables as short as six feet. This feature is now standard in the model M4 low voltage continuity tester, and available as an option for HiPot (HVX-series) testers. The same circuitry allows for measuring cable length, length to break, capacitance, and resistance with precision (4-wire).
Industry News | 2021-05-31 04:59:56.0
Weight is one of the essential parameters that need to be considered in many fields. The weight of the object needs to be weighted accurately to determine the content of the object. A load cell is commonly used in these situations where accuracy and precision of the weight of the object are important. The load cell is able to measure the weight of object with high accuracy.
Industry News | 2015-09-29 15:57:21.0
CAMI Research Inc. (Acton, MA) offers a comprehensive tolerancing option to its standard CableEye cable and harness testing system Graphical User Interface (GUI). The intuitive, graphic-rich GUI provides a clear simple operator interface and, for resistance measurements, may be user-set asymmetrically in either absolute or percentage parameters.
