Industry News | 2021-05-21 03:56:59.0
LED lamp bead because of energy saving, low carbon environmental protection, no strobe, no radiation, high brightness, low heat advantages are gradually replacing the fluorescent lamp on the market, its application scope is expanding,although LED has many advantages, if the production or operation is not appropriate,there will be LED strip use fault phenomenon. LED lamp strip manufacturers also begin to pay more and more attention to the problem of production quality, then what equipment can be used for LED lamp strip backlight detection? Unicomp Technology here recommended AX8200L LED strip backlight detection equipment.
Industry News | 2019-12-16 22:23:49.0
In recent years, the automotive industry headlights using LED, especially the of large power LED chip more and more. Especially in the headlamp part of the large hernia lamp with high-power high-power LED panel, the effect is very good.
Industry News | 2021-01-05 10:48:14.0
Newly Released ECE SSR offers AC and DC Outputs with a Wide Variety of Available Voltage Options
Industry News | 2021-12-22 20:27:56.0
The mass flow sensor, or air flow sensor is one of the important sensors of the electronic fuel injection engine. It is installed between the air filter and the intake hose to measure the intake volume of the engine cylinder and adjust the fuel ratio according to it. The mass flow sensor converts the inhaled air flow into electrical signals and sends them to the electronic control unit (ECU). As one of the basic signals to determine the fuel injection, it is a sensor that measures the air flow of the suction engine. So if you want to test it, how should you do? Let's start it.
Industry News | 2021-05-31 21:38:35.0
It goes without saying that correct dimensional measurement is a key factor in manufacturing. Performing measurements with the same reference throughout all processes from material reception to processing, assembly, inspection, and shipping make it possible to create products that match the design exactly and to guarantee product quality. Thus, it is essential to perform correct measurements throughout every step of the manufacturing process. Correct measurements can be done by making sure that all those involved in manufacturing are skilled in measuring, and that the measuring instruments are correctly managed and used.
| 1 |
