Electronics Forum | Fri Oct 09 14:01:24 EDT 1998 | Bob Barr
Charles, I am using an Air-Vac PCBRM12 to selectively solder a 96 pin thru-hole connector onto an otherwise all SMT board. Cost is $8.6K plus about $300 per flow well (nozzle.) Went from a 6 minute cycle to hand solder the connector to 15 seconds o
Electronics Forum | Thu Jan 20 15:11:26 EST 2000 | Russ
I tested out the OK unit and found it to be a "down and dirty" rework machine that will do BGAs if demeanding thermal requirements are not needed. My largest concern was the lack of bottom side preheat. I have recently purchased the Air-Vac DRS24 a
Used SMT Equipment | Assembly Accessories
Description Lot# - 13360-97 Condition - Used/See Description Package Lot including all Lots except for Feeders, Changeover Tables and Docking Stations.This Lots contains below assets:ASM / Siemens Siplace 'SX-2' Placement Machine (2020)ASM
Used SMT Equipment | Repair/Rework
Air-Vac Solder Rework Station, model# PCBRM-15. Please refer to the pictures for more detail. It comes with the foot pedals and attachment shown in the pictures. This requires a 208/220/240v power source. It is in good working condition.
Parts & Supplies | Soldering - Reflow
I have 29 Air-Vac Engineering flow wells for PCBRM-12 & 15 machines and 10 cleaning hoods. Also have 17 Wenesco solder flow nozzles that came with the PCBRM-12 that I have. Also a few unknown mfg. flow wells. I would like to entertain someo
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/products/adhesive-dispensing-systems-products/unity-ic-series-dispensers
) Adhesive viscosity Varies depending on nozzle size and flow rate Solenoid valve air flow 15 scfm minimum Electrical Specifications Unity Controller Supply voltage 200-240 VAC, 1 phase, 50/60 Hz, 290
