Semi-automatic Liquid Dispenser with time control. To push the liquid pneumatically, controlled by time, to be sure the same dispensing drops and dispensing cycle time,regulated the air pressure with suitable tip at your equipments of the different l
New Equipment | Rework & Repair Equipment
The PDR E3G Evolution - Next Generation Rework System - is made of only the finest materials and components for optimum precision and rework excellence. Combining PDR's ThermoActive software technology with PDR's patented Focused - Visible IR Techno
Electronics Forum | Thu May 06 17:17:59 EDT 2004 | Bruce
I am glad this thread is still alive as I have a concern. I have just entered the wave soldering business after many years in smt. After wave I am getting icicles or flags on my component leeds. My temps seem to be all with in spec as does my NC flux
Electronics Forum | Fri May 07 16:24:08 EDT 2004 | bruce @ knoll
I did have my solder analyzed and it is clean. The Hollis preheat coils are a bit hard to control but I have measured the board top side and I am getting a temp of 105c just before wave contact. I would like to move to a spray fluxer but I am going
Buy and selling used smt，semi， Robot ,CNC and all used machines
Equipment Dealer / Broker / Auctions
DONGGUAN HUMEN
Dongguan, 30 China
Phone: 13560819457
