Electronics Forum | Thu Nov 30 16:31:40 EST 2006 | techgonecrazy
This has been a problem from the start. I used a digital flowmeter to check exhaust and both sides are pretty even, however, I do not know if its exhausting too much or not enough, just going on the PE specs...but then again...do they really know. I
Electronics Forum | Wed Nov 29 16:52:35 EST 2006 | techgonecrazy
OK... My problem with BTUs is that they are getting stopped up because the flux is not going from vapor form to liquid form; instead it is crystalizing (looks like a blizzard took place in the flux box and chiller boxes) and clogging up the flux box,
Used SMT Equipment | Soldering - Reflow
Please go to Web site link for details and pictures. Unit is very clean as it was PM'd every 30 days. Inside looks like new. Very well optioned: Left to right Edge with center rail support N2 with water cooling (chiller available)
Used SMT Equipment | Soldering - Reflow
BTU PARAGON 150 Oven D.O.M.:1997 S/N:LLK-11 10 Zone L-R process flow; edge rail conveyor; lead free oven; 325C max temp rating; two cooling zones; 208 3-Phase Machine being auctioned off May 15th - 17th at the following link: http://cardinalc
winsouce.jpg)
