Electronics Forum | Thu Feb 08 09:41:23 EST 2007 | SWAG
Check the bare board - could also be an unmasked via on the heel of the pad that is sucking solder into it.
Electronics Forum | Thu Feb 08 08:54:56 EST 2007 | jhaviland
groundplane not heating properly.. Is it a J leaded IC? sometimes these get bent slightly in the packaging and sit just far enough off the board to cause solder problems.
Industry News | 2022-01-10 16:55:15.0
The SMTA Capital Chapter Officer team is excited to provide our members with a free technical webinar on "Use of Photonic Soldering to Rework Chip Components" presented by Dr. Vahid Akhavan, Global Application Engineer at NovaCentrix. The presentation will take place on January 20th at 12:00am EST.
Industry News | 2018-10-18 09:14:05.0
Lead-free processes propose new requirements on reflow soldering quality
SMTnet Express, May 9, 2019, Subscribers: 31,902, Companies: 10,760, Users: 26,083 Cold Ball Pull Test Efficiency for the PCB Pad Cratering Validation with the Ultra Low Loss Dielectric Material Credits: iNEMI (International Electronics
Heller Industries Inc. | https://hellerindustries.com/parts/800531/
? Reflow Soldering Problems Overview Causes & Defects – Reflow Soldering Solder Ball Defects Opensor Insufficient Solder Wicking Defects Tombstoning PCB Soldering PCB Bridging Defects PCB Dewetting PCB Nonwetting Circuit Board Voids PCB Delamination
ASYMTEK Products | Nordson Electronics Solutions | https://www.nordson.com/en/divisions/dage/test-types/cold-bump-pull?con=t&page=7
Contact Global HQ Africa Asia Central and South America Europe USA and Canada Cold Bump Pull Nordson DAGE bondtesters provide cold bump pull tests to vertically remove the solder ball from a device or
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
