Electronics Forum | Fri Nov 03 07:28:27 EST 2006 | davef
Via filling methods are: * Tenting * Plugging * Capping * Flooding Tented Via. A via covered with dry film soldermask; the via is not filled. When tenting from both sides there may be issues with trapped air that expands during mass soldering. Plug
Electronics Forum | Mon Mar 26 07:38:26 EDT 2007 | davef
The temperature that will melt solder holding top side SMT components during wave soldering depends on the alloy of that solder. So, for example, you'd expect: * Near eutectic SnPb solder to melt around 215*C. * LF to melt around 240*C. It's common
Influence of Nanoparticles, Low Melting Point (LMP) Fillers, and Conducting Polymers on Electrical, Mechanical, and Reliability Performance of Micro-Filled Conducting Adhesives for Z-Axis Interconnections. Influence of Nanoparticles, Low Melting
SMTnet Express, May 4, 2017, Subscribers: 30,444, Companies: 10,591, Users: 23,216 Development of a Consistent and Reliable Thermal Conductivity Measurement Method, Adapted to Typical Composite Materials Used in the PCB Industry Francois
