Electronics Forum | Wed Sep 03 07:43:13 EDT 2008 | davef
What do you mean by a "few micron thick"? IMC thickness pre-cycling (NEMI Lead-free) * Cu3Sn: 3um [118 uin] * Cu6Sn5: 1um [40 uin]
Electronics Forum | Thu Nov 03 13:35:46 EST 2005 | Amol
the copper forms intermetallics with tin to get Cu3Sn and Cu6Sn5. thus intermetallics formation consumes Cu and depends upon the cooling rate, faster the cooling rate, lesser the intermetallic formation
Industry News | 2011-12-30 23:26:12.0
Nihon Superior has highlighted the effectiveness of Cu and Ni as the essential elements in forming a stable IMC layer in lead-free soldering.
Industry News | 2011-10-16 00:20:48.0
Nihon Superior announces that Keith Sweatman will present a paper titled “The Effect of Microalloy Additions on the Morphology and Growth of Interfacial Intermetallic in Low-Ag and No-Ag Pb-Free Solders” at the upcoming SMTA International 2011.
Technical Library | 2010-07-08 19:49:59.0
Aging characteristics of new lead free solder alloys are in question by many experts because of higher amount of tin’s effect on the diffusion of other metals, primarily copper, to create undesirable boundary intermetallics over long periods of time and even moderately elevated temperatures. A primary layer of intermetallics, Cu6Sn5 forms as the liquid solder makes contact with the solid copper substrate. This reaction however ceases as the solder temperature falls below that of liquidus. A secondary intermetallic Cu3Sn1, an undesirable weak and brittle layer, is thought to form over time and may be accelerated by even mildly elevated temperatures in electronic modules such as laptops under power. This project was designed to quantify the growth rate of Cu3Sn1 over an extended period of time in a thermal environment similar to a laptop in the power on mode.
Technical Library | 2019-06-20 00:09:49.0
It is well known that during service the layer of Cu6Sn5 intermetallic at the interface between the solder and a Cu substrate grows but the usual concern has been that if this layer gets too thick it will be the brittleness of this intermetallic that will compromise the reliability of the joint, particularly in impact loading. There is another level of concern when the Cu-rich Cu3Sn phase starts to develop at the Cu6Sn5/Cu interface and an imbalance in the diffusion of atomic species, Sn and Cu, across that interface results in the formation at the Cu3Sn/Cu interface of Kirkendall voids, which can also compromise reliability in impact loading. However, when, as is the case in some microelectronics, the copper substrate is thin in relation to the volume of solder in the joint an overriding concern is that all of the Cu will be consumed by reaction with Sn to form these intermetallics.This paper reports an investigation into the kinetics of the growth of the interfacial intermetallic, and the consequent reduction in the thickness of the Cu substrate in solder joints made with three alloys, Sn-3.0Ag-0.5Cu, Sn-0.7Cu-0.05Ni and Sn-1.5Bi-0.7Cu-0.05Ni.
winsouce.jpg)
