Electronics Forum | Fri Aug 13 16:54:20 EDT 2004 | davef
If the terminations on your components are not barrier plated, you must be very careful about the amount of time you stay above liquidous. As you'd expect, longer is not better. The longer you stay at liquidous, the more of the component terminatio
Electronics Forum | Thu Aug 24 13:20:24 EDT 2000 | Murad Kurwa
One of our divisions is having this problem: - De-wetting on the smt pads and componenent termination on the bottom side after top side procssed through reflow. Board finish is immersion silver. ? Any recommendation on what we should check & verify
Industry News | 2018-12-08 03:24:24.0
RoHS Guide in Electronics: RoHS, WEEE and Lead-Free FAQ
Industry News | 2018-12-08 03:29:29.0
SMT Dictionary – Surface Mount Technology Acronym and Abbreviation
| https://www.eptac.com/are-voids-in-solder-joints-really-an-issue/
. The solder joint has to be metallurgically bonded to the basis material, be it either tin, copper, silver, nickel, brass, etc. and we need to create the intermetallic compound, which allows the wetting between tin of the solder alloy and the basis material
