Electronics Forum | Fri Aug 29 09:39:08 EDT 2014 | rgduval
I'll try to deal with the issues as you've presented them. 1. Blistering/delamination, shown in photo 2. The most likely cause of blistering/delamination like this is moisture in the boards. The moisture can get into the boards in multiple ways..
Electronics Forum | Thu Dec 09 23:57:41 EST 1999 | Jeff Sanchez
Mike, A drag solder system is not so bad. If it's not discoloring the silk screen , damaging your parts or blistering your boards than it looks like a safe bet. I am not sure what other components you have on the boards besides the LED's? But the
SMT Express, Issue No. 3 - from SMTnet.com Volume 1, Issue No. 3 Wednesday, August 18, 1999 Featured Article Return to Front Page BGA REWORK Earl Moon Proof Of Design (POD) COMPARE PART SQUARENESS TO BOARD'S SILK-SCREEN OR TRACES A part
winsouce.jpg)