Electronics Forum | Fri Apr 16 15:12:12 EDT 2021 | jsmith01
Does anyone know where the power to the lambda, chip sensors comes from on a Electrovert EPK plus? I have an intermediate issue with these sensors loosing power and the wave just keeps going higher and flows over the pot. I have replaced the senors
Electronics Forum | Mon Sep 25 23:09:24 EDT 2006 | Chris G
I would suggest an Electrovert EPK Plus. It is cheap, easy to maintain, and Electrovert provides good support. You can get a refurbished lead free EPK for less than 50k. They usually come with USI spray fluxers, which is a pretty good thing, and c
Used SMT Equipment | Soldering - Wave
Electrovert Econopak Plus Wave Solder Machine • Finger Conveyor • Foam Fluxer • 2 bottom Convection Pre-Heat • 2 Top side Stainless Steel Deflector Plates over Pre-Heat • 16” Usable Single Wave • Cast Iron Solder Pot • Roll-out solder pot •
Used SMT Equipment | Soldering - Wave
EPK Plus 400F 09/1999 440VAC 3 phase, L to R Board Flow, V Fingers, 16" Process width, USI Opti Flux External Spray Cabinet, Convection pre-heat with Top Side IR Heat, Chip Wave, Lambda Wave, N2 Capable, Was used in a climate controlled facility/env
Industry News | 2014-06-12 18:40:43.0
The new Electrovert® Electra™ by Speedline Technologies® is the "Next Generation" in wave soldering systems, offering innovative new features and enhanced performance that make it the most ‘state-of-the-art’ wave soldering system to be launched into the marketplace to date, according to Geoff Klein, Electrovert's General Manager.
Parts & Supplies | Soldering - Wave
Replacement IR Pre-heaters for Electrovert EPK I model wave soldering machines. Two Available. FOB: MN
Career Center | Bangalore-560026, Karnataka India | Engineering,Maintenance,Technical Support
New Product Introduction & Product dovelopment
