Electronics Forum | Wed Jun 14 11:37:44 EDT 2006 | shawnvike
find the problem? Were the parts failing > electrically? Or did someone start prying them > and decide they were too weak? Originally found the problem going through some older assemblies that had failed testing. Poked at leads and found them no
Electronics Forum | Fri Dec 17 12:09:09 EST 1999 | Boca
Outstanding advice gentlemen! To borrow Dave F's line "I'd like to take a bit of a different angle." Ie. a few wave solder specific issues If this assembly is going over wave solder then avoid vias under passive components, it invites solder bal
Industry News | 2010-07-08 12:45:56.0
Working together to address the latest round of proposed substance restrictions, IPC and the Indian Printed Circuits Association (IPCA) have submitted comments in response to the Indian Government’s Ministry of Environment and Forests draft notification of E-waste (Management and Handling) Rules 2010.
Industry News | 2021-05-25 12:56:56.0
The SMTA Officer team is excited to provide our members with a free technical webinar on "The Relationship Between Cleanliness and Reliability/Durability" by Debbie Carboni, Global Product Manager at KYZEN Corporation. The presentation will take place on June 10th at 11:00am EST and include:
Technical Library | 2020-12-07 15:26:06.0
Temperature cycling testing is a method of accelerated life testing done to PCCs that are exposed to normal operation temperature variations over its lifetime. During the testing, intermittent "open" failures can first occur at the hot and cold extremes of the test, exposing weaknesses in the design and assembly. A poor/weak solder joint fatigues, a via trace or barrel cracks, loose connections or a component fails all causing an intermittent open. When not at extreme temperatures, the PCC assembly relaxes, the "open" closes creating electrical connectivity. If you are monitoring the PCC under test in-situ you will know that an intermittent failure has occurred, and the test could be stopped for inspection. If in-situ monitoring was not implemented, you would not know if there were intermittent failures or not. The PCC gets powered up and works fine at room temperature.
The Environmental Cost of Green The Environmental Cost of Green Being involved in the electronics assembly industry for more than 23 years, specifically in the field of defluxing and cleanliness testing, I have seen my share of environmental
The Environmental Cost of Green The Environmental Cost of Green Being involved in the electronics assembly industry for more than 23 years, specifically in the field of defluxing and cleanliness testing, I have seen my share of environmental
| https://www.eptac.com/wp-content/uploads/2021/10/EPTAC_DataSheet_AdvMicroSMT.pdf
in size from 0603, 0402, 0201, 01005, as well as multi-leaded extra fine pitch devices. This course is an extensive and repetitive “hands-on” experience
Lewis & Clark | https://www.lewis-clark.com/product-category/pick-place/page/4/
: TPSys 4.2.3b for Ubuntu Linux Details: Electrical Two-Pole Test Electrical Transistor Test Shared Databases HYDRA Electrical Measurement HYDRA High Speed Line Mode HYDRA Large Component Range Proactive Replenishment Monitor Use Outer Slots T3 Table (2
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411