Industry Directory | Consultant / Service Provider
CAD Design Software products run in the AutoCAD environment.
Electronics Forum | Thu Apr 12 20:32:31 EDT 2007 | davef
On one hand, nothing in 8.2.5.4 that states that you need a heel fillet. It only talks to the length of the side fillet. On the other hand, we suggest that you should use 8.2.5.6 to determine if your heel fillet is acceptable, after you have determ
Electronics Forum | Mon Jul 31 03:50:26 EDT 2023 | calebcsmt
Is below the correct interpretation of IPC 610/JSTD requirements for FLAT LUG LEADS (seen on USBs and Diodes mainly) For class 1 or 2, no toe wetting would be required as minimum side joint is only 'evident wetting' and no actual length or fillet he
Used SMT Equipment | AOI / Automated Optical Inspection
OMRON AOI VT-S720-A MACHINE Hardware Configuration Image signal input unit Main unit Power supply Air Camera Illumination Image resolution Feed method Line height PCB carrier width adjustment Ambient operating temperature Ambient opera
Industry News | 2010-09-30 00:35:51.0
The new E revisions of IPC’s popular desk reference manuals, IPC-DRM-PTH, Through-Hole Solder Joint Evaluation Training & Reference Guide and IPC-DRM-SMT, Surface Mount Solder Joint Evaluation Training & Reference Guide have been released.
Industry News | 2018-10-18 08:43:30.0
Pin-in-Paste Reflow Calculations and Special Cases
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/07/pan_APEX06.pdf
(1206, 0805, 0603, and 0402) are compared across the different profiles. Note that 1206 means a component with a nominal length of .12 inch (3.0 mm
.gif)
.png)
