Electronics Forum | Wed Sep 14 15:42:45 EDT 2011 | nowak18
During temperature cycling we have determined that the conformal coating wicking underneath our BGAs has caused fractures in our solder balls. One proposed solution is to run an RTV dam around the parameter of the BGA to prevent the CC from wicking u
Electronics Forum | Wed Jun 30 12:41:25 EDT 2010 | rgduval
In general, if the process has been consistent for a period of time, then one should look at any new variables in the process. Therefore...the supposition that there's a bad lot of components is a very good one. Did Yageo offer any possible explana
Industry News | 2013-10-21 16:05:48.0
IPC – Association Connecting Electronics Industries® presented Committee Leadership, Special Recognition and Distinguished Committee Service Awards at IPC’s Fall Standards Development Committee Meetings last week in Fort Worth, Texas.
SMTnet Express, January 27, 2022, Subscribers: 25,985, Companies: 11,506, Users: 27,032 Fracture Toughness Analysis of Epoxy-Recycled Rubber-Based Composite Reinforced with Graphene Nanoplatelets for Structural Applications
| https://www.eptac.com/soldertips/problems-with-stress-cracks-in-ceramic-components/
. Although it may not be seen at this time, the ceramic will fracture when exposed to heat cycles. Solder paste, Tin/Lead or Lead-Free. Lead-Free is more brittle and the stress relief will be absorbed by the component causing it to crack
Surface Mount Technology Association (SMTA) | https://www.smta.org/knowledge/journal.cfm
Shorey Abstract 30-4 1000 Days of Testing Tin Whiskering PCB Assemblies to Determine the Suitability of Conformal Coatings to Mitigate Against Shorting Martin Wickham, Adam Lewis and Kate Clayton
.gif)
