Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob
Electronics Forum | Wed Jun 21 04:11:31 EDT 2006 | daxman
Are you familar with using the mecca mode on Fuji machines? There is a procedure I can take you through that will check the servo amp and allow you to adjust it. Is your machine useable at all? can you get it to pass zero set? If you can, view your s
Used SMT Equipment | SMT Equipment
ADBHF8060 QP351E-OF SAM6580 SERVO MOTOR SGMAH-A5A1A4C (AC,50W,Multi Phase) MTU9E(TY) SAM6590 SERVO MOTOR SGMAH-04A1A4C (AC,400W,Multi Phase) MTU9E(TZ) SAM6600 SERVO MOTOR SGMM-A1C3FJ14 (AC,10W,Multi Phase) QP341E/NP1(Q) POWER SUPPLY P/N:T4195E D
_1.JPG)
Parts & Supplies | Pick and Place/Feeders
Fuji Stopper DNPH2100 of XP142 XP143 A lot of FUJI CP6 /CP643/CP7/XP/NXT/IP3 original stock parts: 1. CP642/CP643 X-axis servo box; CP643 Z, FQ, FRQ, NC*** and second-hand axis servo box. 2. CP6/CP642/CP643 original cutting knife, movable knife:
_1.JPG)
Parts & Supplies | Pick and Place/Feeders
FUJI XPF mark hook AGGPH8880 A lot of FUJI CP6 /CP643/CP7/XP/NXT/IP3 original stock parts: 1. CP642/CP643 X-axis servo box; CP643 Z, FQ, FRQ, NC*** and second-hand axis servo box. 2. CP6/CP642/CP643 original cutting knife, movable knife: WPK0312
winsouce.jpg)