Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Wed Feb 16 09:19:22 EST 2000 | MARK ALDER
Please check Circuit Assembly March 1998, article "Solder balls and aperture shapes" and August 1999 "Guiding stencil design". They can be contacted at www.circuitassembly.com The main cause of mid chip solder balls is the volume of paste that is p
Design Authors: Leonard Marks and James A. Cateri
SMTnet Express, March 16, 2017, Subscribers: 30,295, Companies: 15,177, Users: 42,073 Best Practices for RoHS Compliance in support of CE Marking Randy Flinders; GreenSoft Technology, Inc. In 2012, The European Directive on Reduction of Hazardous
winsouce.jpg)