Electronics Forum | Wed Jun 11 10:24:23 EDT 2003 | kris
Hi, The percentage of lead (0.1% or otherwise) is still being debated in the EU where the legislation is in place. The industry is pushing for a 0.2% limit,(if lead-free has to be) as it is considered a limit where solder can be recycled economical
Electronics Forum | Mon Jul 07 11:46:29 EDT 2008 | aj
Hi All, Can anyone advise the spec for land size of a lead 0.2mm in width? I am placing a TQFP128 0.4mm pitch, the leads seem to be wider than the actual pads they are been placed on? I am also experiencing poor wetting on this part , it has NiPdAU
Used SMT Equipment | Soldering - Wave
This Lead Free wave was building boards 01 of 2016 and is ready to go. It has Lambda and chip waves but the Lambda was uninstalled because they did not use. I have it and it does come with the machine.
Used SMT Equipment | THT Equipment
Q-Corp Lead-O-Matic Model 90003 Lead Trimer. FOB: Origin located in the Midwest USAContact - AssuredTechnicalServiceLLC@Gmail.com
PCB Libraries, Inc. | https://www.pcblibraries.com/forum/clipped-leads-for-dpaks_topic3101_post12367.html
: 05 Jan 2012 Location: San Diego, CA Status: Offline Points: 5251 Post Options Post Reply Quote Tom H Report Post Thanks(0) Quote Reply Topic: Clipped leads for DPAKs
GPD Global | https://www.gpd-global.com/co_website/pdf/lead-former/CF8-Transport-Wheel-Idler-Gear-Lash-Adjustment.pdf
& 7 bringing the wire clamp down so it almost touches the leads. c. With an inspection mirror, verify that the leads are in the center of the roller. If the leads