Electronics Forum | Wed Apr 15 09:59:56 EDT 1998 | Miangui Xue
I have a hermetic package with 1 atm of Helium (5% vol.) and Argon (95%) inside. We have detected the helium leaks at 5*e-8 ccatm/sec. My question is what is the leaking rate of argon. Can anybody provide any insight or information to calculate the r
Electronics Forum | Tue Nov 14 08:52:07 EST 2017 | davef
If you think the problem is occurring in the box and it is wide spread, consider replacing your solder paste with your paste supplier. There are paste formulations aimed at the solder balling issue that some LF pastes create. On tuning your reflow r
Industry News | 2021-12-03 20:03:25.0
Differential pressure transmitter is a kind of pressure measuring instrument widely used in all kinds of chemical industry. Working principle of differential pressure transmitter is as follows. The differential pressure from the two-sided pressure pipes acts directly on the two-sided isolation diaphragm of the differential pressure transmitter sensor, and is transmitted to the measuring element through the sealing fluid in the diaphragm. The measuring element converts the measured differential pressure signal into the corresponding electrical signal and transmits it to the converter. After amplification and other processing, it becomes the standard electrical signal and then is output.
Industry News | 2021-08-12 20:58:16.0
When we use the Refrigeration Compressors, there could be frosting. It's a failure that we can solve. So this article will take you to look at the reasons for frosting and the corresponding solutions.
| https://www.wesource.com/miscellaneous/resys-ultra-loop-pcb-water-recycling-system-w/sump-pump-id-140319/
& Chemical Interface Ports Model# HEATER S/N# 1234 480V, 60HZ, 3PH, 45A LOW OPERATING HOURS: 240 hours A REsys closed loop will provide heated DI water at a consistent flow and pressure rate while conserving both water and energy
