Electronics Forum | Fri Jul 18 16:04:31 EDT 2014 | comatose
We had this. The anti-backlash nuts were binding. We took them apart, chased the threads with a tap and re-assembled with slightly less pre-load. Hasn't been a problem since.
Electronics Forum | Mon Jul 21 11:01:11 EDT 2014 | dontfeedphils
I dealt with the same issue for a month or so. We jumped through a lot of hoops, replaced both lead screws, verified the motor was good, a ton of stuff. Ended up being an intermittent wire connection between the control board and the conveyor width
Industry News | 2015-05-18 21:29:50.0
The SMTA Capital Chapter is pleased to announce its second meeting of 2015 on May 28th, scheduled from 5:30 pm to 8:00 pm at NTS Baltimore formerly Trace Labs, 5 North Park Drive, Hunt Valley, MD 21030. The focus of this chapter meeting will be “Failure Analysis Process for Printed Board Assemblies” presented by John M. Radman, Senior Applications Engineer, NTS Baltimore.
Industry News | 2003-04-07 14:15:37.0
eM-Assembly Expert 2.0 Improves Electronics Manufacturers' New Product Introduction Processes
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/FLOwareGEMInterface_1.2.0.pdf
Acknowledge (HE)..................................................................72 7.2.9 S2, F23 Trace Initialize Send (HE) ....................................................................................73 7.2.10 S2, F24 Trace Initialize Acknowledge (H
Heller Industries Inc. | https://hellerindustries.com/wp-content/uploads/2018/07/last-will-of-bga-void.pdf
Test Vehicle Assembly The test vehicles were assembled at the Rockwell Collins Coralville production facility. An MPM Ultra Print 2000 automated stencil printer using a 0.005 inch thick stainless steel stencil applied solder paste to the test vehicles
winsouce.jpg)
.gif)
