Electronics Forum | Thu Aug 16 08:15:04 EDT 2018 | muzzy
Hello! Does anybody know how to access the "MS Parameters" window on older JUKI Pick and place machines? (mainly on 730, 740, 750, 760). Service manual mentions that it is possible to change all of the mechanical parameters from there (like for examp
Electronics Forum | Thu Aug 16 09:15:15 EDT 2018 | muzzy
Sarason, thank you very much for your reply. I already have this manual but, unfortunately, it only mentions this elusive "MS Parameters" window but doesn't state how to get there and what is the password. Regards, M.
ML-2500S PCB Separator uses high speed rotation milling cutter to separate PCB array. Widely applied in digital, communication, lighting, etc. Which improved the defect on PCB separating caused by manual, V-cut, stamping, etc If you have any questi
