Electronics Forum | Wed Jun 27 14:36:22 EDT 2012 | cyber_wolf
If the X axis is moving then maybe your Elmo is not adjusted correctly. There is a procedure to adjust it in the manual(assuming you have the original manual). The correct location is XGTS which is a white connector on the booster. The fans are 24V
Electronics Forum | Fri Jul 10 18:47:27 EDT 2015 | alphatronique
make sure noting stock in the X ,and motor brake work usually machine supply 24V to motor brake wire for release brake then move until hit the end stopper for init motor if brake keep on that will the error message i got it often on the Z cause
Parts & Supplies | Chipshooters / Chip Mounters
Genuine MYDATA parts Brand New; Used( good condition). Available in stock. Quick shipping; Any interesting, feel free to contact via mail: yzfs1968@aliyun.com, Mobile: +86-13501595476 Parts No. Description L-050-0015 VAC
| https://unisoft-cim.com/pcbtest.php
1.095 0.520 Bottom 0.000 0.000 +24V U59 3 8.758 4.439 Top 0.000 0.000 MUXOUT VIA1440 1 8.683 4.438 Both 0.000 0.000 MUXOUT U26 44 1.900 3.958 Top 0.000 0.000 MOSI U36 1 0.510 2.168 Top 0.000 0.000 MOSI VIA659 1 1.812 3.799 Both 0.000 0.000 MOSI VIA660 1 0.517 2.780 Both 0.000 0.000 MOSI CR1 2 3.318 2.297 Top 0.000 0.000 NC U13 10 6.303 3.985 Top 0.000 0.000 NC GENRAD OUTPUT
winsouce.jpg)
