Electronics Forum | Fri Mar 06 14:33:53 EST 2020 | bk
Another thing you can check is where the bar comes down off of the hydra z motor there is a little bearing you can see from the front make sure that bearing is turning even oil it up a little. You can also adjust the tension by loosening the tiny set
Electronics Forum | Thu Jul 19 17:10:43 EDT 2007 | jamyboy
You might want to check the Xwagon bearings. We had the same issue with the TP9-UFP we ordered all the possible parts Xmotors small large, encoder, transducer, couplings etc. over 10K worth of parts. The only thing we didnt order was the actual x-wag
Industry News | 2020-07-29 09:40:02.0
NPI line complements two high-speed, high-mix surface mount technology (SMT) production lines to bring new products to market faster
Career Center | hyd, andhra pradesh India | Engineering,Production,Research and Development,Technical Support
i have a experience in smt and i acan operate europlacer and mydata machines.
| https://www.feedersupplier.com/sale-13067676-panasonic-cm-label-feeder-2mm-width-smt-feeders.html
, HITACHI, MIRAE , MYDATA and so on. products show Other produccts Our company deals in the following products: 1.SMT equipment and accessories
| https://pcbasupplies.com/bar-solder/
& Mydata Panasonic Quad - PPM RT10 Rubber Tips Speedline Technologies Camalot Universal Instruments Yamaha | IPulse SMT Custom Nozzles Cree LED Lumileds LEDs Nichia LEDs OSRAM LEDs Other Custom Nozzles Other LEDs Selective Solder Nozzles Ace Production Technologies Pillarhouse ID Threaded Nozzles OD Threaded Nozzles RPS
