Electronics Forum | Thu Oct 25 11:15:55 EDT 2012 | aj
are you sure the zone 5 blower is running? sounds like it isnt.... no harm to check all blowers while you are at it.
Electronics Forum | Thu Oct 25 10:05:05 EDT 2012 | kz9yyc
Hello all, I am having difficulty with an OmniExcel 10 oven. Zone 5 upper will not hold setpoint = 165C (it typically runs ~10C higher). Here is what I know: 1. The machine is not turning on zone 5 heat when temp is too high. 2. Zone 5 lower is
Used SMT Equipment | Soldering - Reflow
Speedline Electrovert OmniExcel 10 Reflow
Used SMT Equipment | Soldering - Reflow
Electrovert Omni Excel 10 SN : 10-15033 Vintage 2006 Left to right Wire mesh and rail Front fixed Pics : http://www.slimtech-smt.com/Omniexcel10-2006-SN-EX10-15033/ Elexin Engineering
