Count On Tools specializes in custom engineered nozzles for all types of LEDs (Cree, Luxeon, Phillips, NIchia, Osram, etc). Recent growth in LED technology and solid state lighting has provided the electronics manufacturing industry with viable sol
Electronics Forum | Tue Aug 28 12:05:42 EDT 2001 | mparker
The advantage of DPMO is that the numbers used are PPM, (Part Per Million), rather than percentage. Percentage can distort, depending on volume. For instance, 100 units processed, 25 defects found = 75 percent yield. 4 units processed, 1 defect found
Electronics Forum | Mon Sep 16 13:29:37 EDT 2013 | larrygroves
a lot depends on the age and type of equipment you are using . Older equipment can have a lot of problems with smaller parts. If all is well with your feeders and machine you should expect something like 99.8 to 99.9 percent. some parts will be ident
Industry News | 2003-06-10 08:16:44.0
The following text describes the application of NWA Quality Analyst to quality control in the assembly of electronic components.
Industry News | 2011-07-20 11:59:01.0
MIRTEC reports continued growth in sales revenue for its North American Sales and Service Division for 2011.
Career Center | Houston, Texas USA | Engineering,Management,Production
SMT Manufacturing Engineer – 2nd Shift Hunting Innova is a Houston based company serving industrial, energy, medical, defense and aerospace segments of the Electronic Manufacturing Services (EMS) Industry since 1989. Hunting Innova is located in N
| http://www.thebranfordgroup.com/dnn3/Auction/DZSG0222.aspx
, Retention A set-off or retention by the Contractual Partner shall only be permissible if the alleged counter-right is a claim that is uncontested, non-appealable or ready for decision, or if the Contractual Partner asserts a defect-related counter-right
GPD Global | https://www.gpd-global.com/co_website/pdf/doc/Side-Mount-Loader-Unloader-Guide-24000600.pdf
. Neighboring parts must be covered, and the voltage must be checked for those parts disconnected from the power supply. In case of defect, use the Emergency Stop button on the operator panel to stop the machine
